Home
RSS
Twit
make sure you get yourself spay paint and adhesion promoter.
first start off by removing your fog lights. it’s just one screw right in the front and a clip in the back.
pop your hood and take a look at my picture. pop all these tabs off with a screw driver. i have circled everything to make it easy.
Headlight painting
make sure you get yourself spay paint and adhesion promoter.
first start off by removing your fog lights. it’s just one screw right in the front and a clip in the back.
pop your hood and take a look at my picture. pop all these tabs off with a screw driver. i have circled everything to make it easy.
Paint Your Headlight the right way
First you want to sand with 220….Dont be lazy sand it and get all the corners
After you do that wipe it down with Lacquer Thiner or equivalent.
Be careful with this stuff it wont eat your paint but allot of plastics especially clear plastics dont like this stuff.
Installation of lowering springs on 07-08 GD3
DIY: Installation of lowering springs on a GD3 Fit
The following Do-It-Yourself article is for the installation of lowering springs on a 2007-2008 Honda Fit. This is a slightly more advanced installation and I am not responsible for any damage or injury that may occur during your installation by following these directions.
Adapter for Aux to Stereo Headphone Jack to connect to MP3 player or IPod
With this adapter you can connect your audio devices to your Honda Jazz’s factory head unit.The back of head unit is like this.
Install Progress Rear Swaybar
This is the best mods I have done to the Fit in terms of performance. It was just as good as when I upgraded my Integra to the 22mm ITR rear swaybar. The install is pretty easy and shouldn’t take you more than an 45 minutes. I don’t remember all the wrench sizes that I used, so I apologize about that. I did use red loctite for the nuts and bolts to make sure it doesn’t come off in the future.
Headlight painting
Posted by diymyhonda on February 21st, 2010
09 Honda Accord’s Horn Upgrade
Posted by diymyhonda on February 21st, 2010
This is easy and can be done within 15 minutes. The 09 Accord’s horn is much louder than the rinkydink Fit’s horn. No longer where you’ll be laughed at when they hear a freight train coming.
Materials needed:
- Flat head screwdriver
- 12mm Socket & Ratchet.
- 09 Accord’s Horn (Part #38100-STK-A02)
- 15 Minutes.
First remove these 8 Clips [...]
Install Cup Holder LED’s GE8
Posted by diymyhonda on February 21st, 2010
I dont know if Honda was lazy or they felt it wasnt necessary, but the thing that bothered me was i couldnt see a damn thing in the car at night. i had to feel around for stuff especially around the cup holder area. my scion tc and my dads TL all have Leds near [...]